JVC LYT1300-001A - Manual (Page 9)

EN
9
Master Page: Right-start
GETT
ING ST
AR
TED
This player’s 2-way power supply system lets you
choose the most appropriate source of power. Do
not use provided power supply units with other
equipment.
Charging The Battery Pack
1
Make sure you unplug the player’s DC cord from
the AC Power Adapter/Charger.
2
Plug the AC Power Adapter/Charger’s power cord
into an AC outlet. The POWER indicator lights.
3
Attach the battery pack with the YZ mark
aligned with the corresponding marks on the AC
Power Adapter/Charger. The CHARGE indicator
begins blinking to indicate charging has started.
4
When the CHARGE indicator stops blinking but
stays lit, charging is finished. Remove the battery
pack.
5
Unplug the AC Power Adapter/Charger’s power
cord from the AC outlet.
* Provided
NOTES:
● If the protective cap is attached to the battery
pack, remove it first.
● If you connect the player’s DC cord to the AC
Power Adapter/Charger during battery charging,
power is supplied to the player and charging stops.
● Charging is not possible if the wrong type of
battery is used.
● When charging the battery pack for the first time
or after a long storage period, the CHARGE
indicator may not light. In this case, remove the
battery pack from the AC Power Adapter/Charger,
then try charging again.
● If the battery operation time remains extremely
short even after having been fully charged, the
battery is worn out and needs to be replaced.
Please purchase a new one.
● For other notes, ੬ pg. 42.
Using The Battery Pack
1
With the arrow on the battery pack pointing to
the left, push the battery pack slightly against the
battery pack mount
a.
2
Slide the battery pack to the left until it locks in
place
b.
To detach the battery pack...
Slide the battery pack to the right slightly while
sliding BATT. RELEASE to detach it.
NOTES:
● Available time is reduced significantly under the
following conditions:
• The LCD monitor is used repeatedly.
• The playback mode is engaged repeatedly.
● Before extended use, it is recommended that you
prepare enough battery packs to cover 3 times the
planned recording time.
Power
Battery pack Charging time
BN-V416U* Approx. 2 hr.
BN-V428U Approx. 3 hr. 20 min.
Battery pack
BN-V416U or
BN-V428U
To AC outlet
POWER indicator
CHARGE indicator DC OUT connector
AC Power Adapter/
Charger
ATTENTION:
Before detaching the power source, make sure
that the player’s power is turned off. Failure to do
so can result in a player malfunction.
BATT.RELEASE
Switch
Arrow
CONTINUED ON NEXT PAGE
CU-VH1E.book Page 9 Friday, March 26, 2004 1:55 PM