Juniper Networks ERX-1410 - Manual (Page 172)

APPENDIX E
Installing ERX System Software E-12
Installing Software in Boot Mode
To install the ERX software in Boot mode, you must access the CLI via
the local console.
To install the software:
1
Obtain the required information for the installation.
2
Access the Boot mode.
3
Assign an IP address to the ERX system.
4
Configure access to the network host.
5 Mount the CD on the network host.
6 Copy the software release file to the ERX system.
7
Reboot the system.
Task 1: Obtain the Required Information
Before you install the software, obtain the following information:
• The IP address of the network host
• The IP address of the ERX system
• The IP address of the next hop to reach the destination network (for
example, a gateway)
• The login name and password for the FTP server
• The procedure for mounting a CD on the network host
Task 2: Access the Boot Mode
To access Boot mode from the local console:
1
At the Privileged Exec prompt, type the reload command.
Information on the reloading process appears.
2 When the countdown begins, press the key sequence <mb>.
This action puts the CLI in Boot mode and the :boot## prompt
appears.
Note: If you do not press the key sequence <mb> before the countdown ends, the
reloading process continues and returns the CLI to the normal User Exec mode.