Juniper Networks ERX-1410 - Manual (Page 97)

Replacing SFPs on GE I/O Modules
ERX Edge Routers
7-5
Figure 7-1 NVS card slot on SRP module
4 Remove the NVS card and place it in the antistatic container.
5 Insert the higher-capacity NVS card into the slot.
6
Push the higher-capacity NVS card as far as you can in the slot.
When you push the card far enough, it will click into place.
7
Replace the faceplate on the NVS card slot.
Replacing SFPs on GE I/O Modules
This section describes how to replace small form-factor pluggable
transceivers (SFPs) on Gigabit Ethernet (GE) modules that support these
devices. A range of SFPs that support different optical modes (multimode
and single mode) and cabling distances is available. You can replace the
SFPs without disabling the interfaces or removing the module from the
system.
Warning: Do not insert any metal object, such as a screwdriver, or place your hand
into an open slot or the backplane when the ERX system is on. Remove jewelry
(including rings, necklaces, and watches) before working on equipment that is
connected to power lines. These actions prevent electric shock and serious burns.
Caution: When handling electronic components, use an antistatic wrist strap
connected to the system’s ESD grounding jack, and hold components by their
edges. Do not touch, pins, leads, or solder connections. Store components in
antistatic bags. These actions help to protect modules from damage by
electrostatic discharge.
Faceplate
Release button
NVS card