Jenn-Air W10379136A - Manual (Page 21)

21
■ Use the Standard Grille brackets for a Standard
Integrated Grille Installation with a closed or open soffit.
2. Using round-head screws (provided with refrigerator), attach
the grille trim piece to the bottom of the grill panel.
NOTE: The grille trim is preinstalled on the panel kits.
Remove Trim Pieces
1. Remove all tape and door bracing from the refrigerator and
freezer doors.
2. Open the refrigerator and freezer doors.
3. Remove the hinge cover pieces from the top and bottom of
the door to expose the holes in the hinges.
NOTE: It is not necessary to remove the hinge side trims as
they will not interfere with the installation.
4. Remove the handle side trims. See the following graphic.
Install Door Panels
NOTE: First open the door opposite from the one to which you
are installing the door panel.
1. Lower the panel mounting bracket onto the adjustment pins
at the top of the door.
2. Locate the studs on the back of the door panel. Slide the
studs, top stud first followed by the bottom stud, into the “J”
pockets in the front of the door.
NOTE: It is the washer in the stud, not the head of the stud,
that is inserted in the “J” pocket.
3. Slide the door panel down, into the “J” pocket in the front of
the door.
4. Repeat steps 1 through 3 to install the second door panel.
5. Using slotted hex-head screws (provided with refrigerator),
attach the mounting bracket (factory installed), located at the
bottom of the refrigerator and freezer doors, to the respective
door panels. Do not fully tighten the screw.
A. Top grille brackets
B. Grille trim piece
A. Hinge cover pieces
B. Handle-side door trim
A
B
B B
A
A
A
A. Door panel
B. Mounting bracket
C. Adjustment pins
A. Washer in stud
B. “J” pocket
C. Stud
A. Bottom hinge
B. Mounting bracket
A
B
C
C
A
B
A B