Jabra EXTREME FOR PC bT530 - Manual (Page 7)

6
en
g
li
sh
Jabra EXTREME – FOR PC
turnInG your heaDset on anD oFF
- Slide the on/off button forward on the side of the headset to
turn on the headset . The LED will flash green for a second when
the headset is on .
- Slide the on/off button backward to turn off the headset .
Pre PaIreD
your headset is already pre paired to the uSb adapter out of the
box . If pairing is deleted and later pairing is needed this is done in
a few easy steps .
1 . Put the uSb adapter into pairing mode by pressing the button
on the uSb adapter until the LED light is solid blue .
2 . Put your headset into pairing mode by pressing the MFb until
the light in the headset is solid blue and wait a few moments .
3 . When the blue light on both headset and uSb adapter is blinking,
pairing is complete and the headset and uSb adapter will connect
automatically and the LED on the uSb adapter turns solid green
and the green LED on the headset is blinking .
PaIrInG your heaDset WIth your Phone
headsets are connected to phones using a procedure called
‘pairing’ . by following a few simple steps, a phone can be paired
with a headset in a matter of minutes .
1. Put the headset in pairing mode
- When you turn on your Jabra EXTREME for the first time, the
headset will automatically start up in pairing mode – i .e . it is
discoverable for your phone . When the headset is in pairing
mode the LED is constantly lit blue .
2. Set your Bluetooth® phone to ‘discover’ the Jabra EXTREME
- Follow your phone’s instruction guide . First make sure that
Bluetooth® is activated on your mobile phone . Then set your
phone to discover the headset . This usually involves going
to a ‘setup,’ ‘ connect’ or ‘Bluetooth®’ menu on your phone and
selecting the option to ‘discover’ or ‘add’ a Bluetooth® device .*
* Phone dependent / For use with PC, Jabra PC Suite needs to be installed and
running on PC