JVC LPT0715-001A - Manual (Page 44)

44
DVD Picture Signal Selection/Zooming
Note:
• Picture Signal Selection is only avail-
able for connecting with a 21 pin Scart
Cable.
• Depending on your TV, NTSC disc may
not playback correctly in colour. In this
case, it is recommended to select the
Picture Signal RGB on step 2.
• Only use RGB setting if your TV is RGB
compatible.
You can select the output signal of
DVD playback picture to the TV
screen as an VIDEO signal or a RGB
signal.
AB C
: Select : Enter
Picture
TV Shape 4:3LB
Video Out Select Video
AB C
: Select : Enter
Picture
TV Shape 4:3LB
Video Out Select Video RGB
Video
2
Press OK (Enter).
Press
or to select the
desired picture signal, “Video”
or “RGB”.
To make SETUP screen disappear, press SET UP MENU.
3
1
Press SET UP MENU in the
stop mode.
Press or to select “Pic-
ture”, then press or to
select “Video Out Select”.
• Turn ON the TV and set to the video input mode.
• Make sure TV/VCR/DVD switch has been slided to VCR/DVD.
Then press DVD to select the DVD mode. (The DVD indicator
will light)
Preparation:
Press ZOOM during playback.
The center part of the image
will be zoomed in.
As you repeatedly press the
OK or ZOOM while “ZOOM” is
selected, the magnification
level changes. Variation of the
levels includes image reduc-
tion.
: Select : Change
Zoom Off
ZOOM
EXIT
This unit will allow you to zoom in on the frame image. You
can then make selections by switching the position of the
frame.
While “ZOOM” is selected, press ZOOM repeatedly to re-
turn to a 1:1 view.
1
2
3
Zooming
Press / or / to view a different part of the frame.
You may move the frame from the center position to UP,
DOWN, LEFT or RIGHT direction.
• If you select “EXIT” and press the OK, you can turn off the
symbol mark, keeping the current magnification level.
• Press CANCEL to restore the zoom point to the center
of the picture.
Note:
• If you use the connection with S-Video cord, be sure to set the
“Video Out Select” at step 2 above to “Video”. If you select
“RGB”, the TV screen will be disturbed.
• If you selected “RGB” at step 2 above, press TV/VCR to select
VCR. (VCR indicator will appear on the display) Otherwise,
the TV screen will be disturbed when you select the channel
with TV’s CHANNEL UP/DOWN buttons.
2A73501AE(42-47) 4/17/02, 8:27 PM 44