John Lewis U33046 JLTDC10 - Manual (Page 23)

Machine settings
ALARM permanent on/off
The alarm is by default always off. To set
permanent alarm on (off):
1. Turn the programme selector to any
programme.
2. Press simultaneously the Intensive and
Long anti-crease buttons and hold
down for approx. 5 seconds.
Adjusting the level of conductivity
Water contains, a variable quantity of
limestone and mineral salts of which
quantities vary according to geographical
locations thus varying its conductivity
values.
Relevant variations of the conductivity of
the water compared to those prefixed by
the factory could slightly influence the
residual humidity of the laundry at the
end of the cycle. Your dryer allows you to
regulate the sensitivity of the drying
sensor based on conductivity values of the
water.
1. Turn the programme selector to any
programme.
2. Press simultaneously the Long anti-
crease and Start/Pause buttons and
hold down for approx. 5 seconds.
3. Press the Start/Pause button until you
set desired level:
low conductivity
<300 µS/cm
medium conductivity
300-600 µS/cm
high conductivity
>600 µS/cm
4. To memorize setting press simultaneously
the Long anti-crease and Start/
Pause buttons or turn knob to Off
position
23