JVC 0505NYMCREBET - Manual (Page 12)

9
En
g
li
s
h
Using the Tuner
You can listen to FM and AM stations. Stations can be tuned in
manually, automatically, or from preset memory storage.
❏ Before listening to the radio:
• Make sure that both the FM and AM antennas are correctly
connected. (See pages 4 and 5.)
Setting the AM Tuner Interval Spacing
When shipped, the AM tuner interval is set to 10 kHz spacing (100
kHz spacing for FM broadcast). You can change it to 9 kHz spacing.
To select 9 kHz intervals, press the
7 button on the Remote
Control for more than 2 seconds in Standby mode, “AM-10” ap-
pears on the display, then press the 9 button on the Remote Control
(at the same time, the 50 kHz spacing is selected for FM broad-
cast).
To select 10 kHz intervals again, press the
7 button on the
Remote Control for more than 2 seconds in Standby mode, “AM-
9” appears on the display, then press the 10 button on the Remote
Control.
One Touch Radio
Just press the FM/AM button to turn on the System and start play-
ing the station you were last tuned to.
❏ You can switch from any other sound source to the radio by
pressing the FM/AM button.
Tuning In a Station
1 Press the FM/AM button.
The Band and Frequency you were last tuned to appear on the
display.
(If the last station was selected using the preset number, the
preset number and frequency appear.)
Each time you press the button, the band alternates between
FM and AM.
FM MODE
SET/DISPLAY
4
* When the System is in use, the display shows other items as well.
For simplicity, we show here only the items described in this section.
Band display, Frequency display, Preset number
FM mode indicators
FM/AM
¢
Á
22
FM/AM
Numeric
keys
on the Unit on the Remote Control
or
LVT1346-001A_E.book Page 9 Wednesday, May 4, 2005 11:38 AM