JVC AV 61S902 - Manual (Page 13)

13
Connections
INPUT 1 INPUT 2 INPUT 3
AUDIO
L
R
MONO MONO MONO
VIDEO
S-VIDEO
OVER OVER OVER
IN
IN
INPUT
A
SPLIT
OUT
INPUT
B
75 Ω
( VHF / UHF )
1) Connect a coaxial cable out from the cable TV wall outlet or external antenna into the RF Input A.
2) Connect a coaxial cable out from the Cable Split Out RF jack into the RF input on the VCR.
3) Connect the yellow video cable from the VCR’s Video Output jack to the TV’s Video Input 1 jack.
4) Connect the white audio cable from the VCR’s Left Audio Output jack to the TV’s Left Audio Input 1 jack.
5) Connect the red audio cable from the VCR’s Right Audio Output jack to the TV’s Right Audio Input 1 jack.
• If you are connecting a mono sound VCR it will have only one audio out jack. Connect it to the TV’s left audio
input jack.
• The VCR signal will be available on Input 1 on the Input Menu (see page 54) if the connection shown above is used.
• Coaxial cables are not included with the television.
• Please consult your VCR’s owners manual for more information on its operation.
You may also choose to connect video devices (VCR, Camcorders, etc) by using an S-Video Cable. S-Video may
be substituted in any of the connections diagrams included here. To use S-Video:
1) Plug an S-Video cable out from the video device and in to the TV’s S-Video Input.
Keep the audio connections the same as shown in the diagrams. Make sure that the S-Video cable and audio
cables are plugged into the same input (for example, S-Video and audio cables into the Input 1 set of jacks).
S-Video Connection
VCR
Yellow
White
Red
Diagram #2