JVC AV 61S902 - Manual (Page 53)

53
Use the number buttons on the remote control to move directly to a specific channel. For example, to move to channel 7:
0 (Zero)
7 (Seven)
Use the 100+ button to directly access channels above Channel 99. For example, to move to channel 124:
100+
2 (Two)
4 (Four)
Number Buttons - 10 Key Pad
100+ Button
The R ETURN + button has two functions:
Return - Returns to the channel viewed just before the channel currently onscreen.
Return+ - Lets you program a specific channel to return to while scanning through the channels. To program:
R ETURN + and hold for three seconds.
You can now scan through the channels using the C H +/- buttons.
R ETURN +
You will return to your programmed channel.
• To cancel your R ETURN + channel, press and hold the R ETURN + button for three seconds. The message
“RETURN CHANNEL CANCELLED!” will appear.
• R ETURN + works only with C HANNEL +/-. Pressing any number key will cancel R ETURN +.
Return+
By pressing the remote control V- CHIP button, the V-chip rating information for the program which is being
received is displayed on the screen.
If the V-chip rating information is not being sent, “UNRATED” is displayed on the screen.
If the zero (“0”) button is pressed while the V-chip rating is displayed on the screen, all categories with the
same or a higher V-chip rating will be blocked.
For example, if you block movies rated NC-17, movies rated X will also be blocked.
• V-chip blocks can be manually set one at a time by using the V-chip option in the INITIAL SETUP menu.
For detailed information about V-chip ratings and V-chip manual settings, refer to pages 33 to 35.
V-chip
Button Functions
RETURN CHANNEL
PROGRAMMED !