JVC HR-A47U - Manual (Page 19)

EN
19
Basic
Recording
1
Load a cassette
Make sure the record safety tab is intact. If not,
cover the hole with adhesive tape before
inserting the cassette.
2 Select recording channel
On the front panel:
Press CH
5∞.
On the Remote:
a– Press CH + or –.
or
b– Press the Number keys.
● If you connect the TV and the VCR only using
the RF connection, press TV/VCR on the Remote
so that the VCR mode indicator lights on the front
display panel, to view the program to be recorded.
3 Set tape speed
Press SP/EP to set the recording speed.
4
Start recording
On the front panel:
Press REC (
¶ ).
On the Remote:
While holding REC (
¶ ), press PLAY ( 3 ).
To pause recording
Press PAUSE ( 8 ). To resume recording, press PLAY ( 3 ).
To stop recording
Press STOP ( 7 ) on the Remote or STOP/EJECT ( 7 / 0 )
on the front panel.
To rewind the tape – when the tape is not running.
Press REW (
1 ).
To fast-forward the tape – when the tape is not running.
Press FF (
¡ ).
To eject the tape
Press STOP/EJECT (
7 / 0 ) on the front panel when the
tape is not running.
● You can also eject the cassette with the VCR turned off.
To turn off the VCR
Press POWER.
Turn on the VCR and the TV, and select the VCR
channel 3 or 4 (or AV mode) on the TV.
Accidental erasure prevention
To prevent accidental
recording on a recorded
cassette, remove its record
safety tab.
To record on it later, cover
the hole with adhesive tape.
Record safety tab
1
7 8 9
2
4
1
3
2 3
4 5 6
0
STOP ( 7 )
FF ( ¡ ) REW ( 1 )
3
2
– a
2
– b
POWER
PAUSE ( 8 )
4
TV/VCR
SP EP VCR
STOP/EJECT
( 7 / 0 )
3
PAUSE ( 8 )
PLAY ( 3 )
POWER
REW ( 1 )
FF ( ¡ )
4
2