JVC HR-A47U - Manual (Page 24)

24
EN TIMER RECORDING
You can directly program the VCR’s timer to record up to
8 broadcasts, as far as a year in advance. Remember, the
clock must be set before you can program the timer (
੬
pg. 8 or 10).
1 Load a cassette
Make sure the record safety tab is intact. If not,
cover the hole with adhesive tape, then load it
into the VCR.
● The VCR turns on, and the counter is reset,
automatically.
2 Access Program screen
Press PROG.. (If no
program is stored,
“PROGRAM 1”
appears.)
3 Set program start time
Press START +/–
repeatedly to enter the
time you want
recording to start.
● Press and hold START
+/– to increase the
time in 30-minute
intervals.
4
Set program stop time
Press STOP +/– repeatedly to enter the time you
want recording to stop.
● Press and hold STOP +/– to increase the time in
30-minute intervals.
5 Set program date
Press DATE +/–. (The current date is displayed on
the screen. The date you enter appears in its
place.)
6
Set channel number
Press CH +/–.
● Holding down CH +/– rapidly changes the
channel numbers.
● If you receive your programs through a cable
box, select the cable box output channel — the
channel on which you view the cable box
programs on the TV.
Express Timer
Programing
Turn on the VCR and the TV, and select the VCR
channel 3 or 4 (or AV mode) on the TV.
PROGRAM 1
START STOP
8:00 AM = – –:– –AM
DATE CH
– –/– –/– – – – – SP
PRESS (+/–, SP/EP, 8=DAILY,
9=WEEKLY), THEN (0K)
PRESS (PROG.) TO END
PROGRAM 1
START STOP
– –:– –AM = – –:– –AM
DATE CH
– –/– –/– – – – – SP
PRESS (+/–, SP/EP, 8=DAILY,
9=WEEKLY), THEN (0K)
PRESS (PROG.) TO END
WEEKLY
POWER
1
7 8 9
2
4
1
3
2 3
4 5 6
0
DAILY
9
7
3
4
2 8
8
6
5