Jura Capresso S7 - Manual (Page 24)

24
Once started, the cleaning process must not be interrupted.
After each cleaning process, the filler funnel for the pre-
ground coffee (17) should be cleaned as well.
Ⅲ
SELECT PRODUCT
CLEAN MACHINE
Ⅲ Press Rinse
until the following message appears:
Ⅲ
EMPTY TRAY /
EMPTY GROUNDS
Ⅲ Empty out the drip tray (1) and integrated coffee grounds bin.
Ⅲ
TRAY
MISSING
Ⅲ Place the empty, clean drip tray (1) and integrated coffee
grounds bin back into the IMPRESSA.
Ⅲ
PRESS
RINSE
Ⅲ Place a sufficiently large receptacle (ca. 0.5 litres) under the
coffee spout (18).
Ⅲ Press Rinse .
Ⅲ
MACHINE
CLEANING
Ⅲ You will hear an acoustic signal.
Ⅲ
ADD
TABLET / PRESS RINSE
Ⅲ Open the lid of the filler funnel for pre-ground coffee (17). Drop
an original JURA cleaning tablet inside (Fig. 12) and close the
lid.
Ⅲ Press Rinse .
Ⅲ
MACHINE
CLEANING
Ⅲ You will hear an acoustic signal.
Ⅲ
EMPTY TRAY /
EMPTY GROUNDS
Ⅲ Empty out the drip tray (1) and integrated coffee grounds bin.
Ⅲ
TRAY
MISSING
Ⅲ Place the empty, clean drip tray (1) and integrated coffee
grounds bin back into the IMPRESSA.
Ⅲ SELECT PRODUCT
Ⅲ When the cleaning program has finished, take out the removable
coffee powder tank and briefly rinse it under running water.
You can also trigger a cleaning cycle manually at any point
in time (see Chapter 13.3).
16. Decalcifying
The IMPRESSA features an integrated decalcifying program. The
process takes approx.50 minutes.
Lime scale builds up in the IMPRESSA as a result of normal
use. The degree of calcification depends on the hardness of
the water you use. The IMPRESSA recognizes when you
should run a decalcifying cycle. The machine will still make
coffee and hot water/steam. However, we recommend that
you should decalcify the machine within a few days after the
message was displayed.
Please only use original JURA de-scaling tablets: their for-
mula is especially tailored to JURA coffee machines. Please
note that the use of unsuitable decalcifying agents may cause
damage to your machine and could leave unfavourable
residues in the water.
Remove any splashes or drops of the decalcifying agent from
sensitive surfaces, in particular surfaces made of natural
stone or wood, or take appropriate preventive measures.