John Lewis JLWD 1406 1400 - Manual (Page 13)

13
9 Display (Programme time)
The following pieces of information are shown on the
display:
• Duration of washing programme in hours and
minutes, after you have selected a programme (for
example 2.05).
The duration is calculated automatically on the basis
of the maximum recommended load for each type of
fabric.
While the programme is running (after you have
pressed the Start/Pause button), the displayed time
value decreases by one unit every minute.
• The washer-dryer has stopped with water in the
tub, at the end of the “Soak 30°”: this is indicated by
a flashing zero.
• The washer-dryer has completed the
programme: this is indicated by a flashing zero.
After starting the programme, the remaining time is
updated every minute.
0
1.25
2.05
• Selection of drying time in minutes .
After starting the programme, the remaining time is
updated every minute.
Important!
If you select a drying time longer then 55’ minutes,
after 3 seconds, the display will show it in hours and
minutes (see the example below).
Example:
• Delay start, a time value indicated in hours (23
hours max) and selected by means of the relevant
button.
The delay time is displayed for 3 seconds, then the
duration of the selected programme reappears.
After you have pressed the Start/Pause button, the
countdown is updated every hour, and, for the last
two hours, every 30 minutes.
• An incorrect option selection has been made:
this is indicated by the message Err when a function
incompatible with the current programme is selected.
Delay
start
Time
dry
1.00 1.00
Time
dry
60 60
105