JVC HM-DH30000U - Manual (Page 27)

EN
27
To pause recording
Press PAUSE ( 8 ). To resume recording, press PLAY ( 3 ).
To stop recording
Press STOP (
7 ) on the Remote or STOP/EJECT ( 7 / 0 )
on the front panel.
To rewind the tape (when it is not running)
Press REW ( 1 ).
To fast-forward the tape (when it is not running)
Press FF (
¡ ).
To eject the tape
Press STOP/EJECT (
7 / 0 ) on the front panel when the
tape is not running.
● You can also eject the cassette when the VCR is turned
off.
To turn off the VCR
Press POWER.
NOTE:
If “MEMORY FULL” appears on the display when you start
recording, the VCR’s memory for the Video Navigation function
is full. This is not related to actual recording, so you can finish
recording normally, but the Video Navigation information such
as recording date, start time, end time, and channel number will
not be stored in memory.
It may be unlawful to record or play back
copyrighted material without the consent of the
copyright owner.
S-VHS/VHS Recording
1 Load a cassette
Make sure the record safety tab is intact. If not,
cover the hole with adhesive tape before
inserting the cassette.
2 Select recording channel
On the front panel:
Press CH + or –.
On the Remote:
a– Press CH + or –.
or
b– Press the Number keys.
3 Set tape speed
Press HS/STD/LS3/SP/EP ( ) to set the
recording speed.
4
Start recording
On the front panel:
Press REC (
¶ ).
On the Remote:
While holding REC (
¶ ), press PLAY ( 3 ).
● If “V, CALIBRATION” is set to “ON” (default
setting: ੬ pg. 53), this VCR checks the tape
condition for about seven seconds, then starts
recording. This means that the first seven
seconds of the program will not be recorded. If
this is inconvenient for you, follow the steps
below:
1 Press REC (
¶ ) and PAUSE ( 8 ) to start
Video Calibration.
2 Then press PLAY (
3 ) to start recording
after Video Calibration is complete.
Compatibility Of Cassettes And Recording Mode
Cassette
Recording Mode
D-VHS S-VHS VHS
D-VHS Yes Yes Yes
S-VHS No Yes Yes
VHS No Yes* Yes
* To record on the VHS cassette with S-VHS quality, use the S-
VHS ET function. ( ੬ pg. 29)
NOTES:
● The D-VHS (MTP), S-VHS and VHS mode recordings are
possible with this VCR.
● To record in the D-VHS mode, use a D-VHS cassette.
● To record in the S-VHS/VHS mode, you can use a D-VHS,
S-VHS or VHS cassette.
To record in S-VHS mode on D-VHS tapes:
Press D-VHS to turn off the D-VHS indicator. Then, set
“S-VHS MODE” to “ON” (
੬ pg. 57).
To record in VHS mode on D-VHS tapes:
Press D-VHS to turn off the D-VHS indicator. Then, set
“S-VHS MODE” to “OFF” (
੬ pg. 57).