Express timer programing – JVC HM-DH30000U User Manual
Page 38
38
EN
TIMER RECORDING (cont.)
You can directly program the VCR’s timer to record up to
8 broadcasts, as far as a year in advance. Remember, the
clock must be set before you can program the timer
(
੬␣ pg. 10).
1
Load a cassette
Make sure the record safety tab is intact. If not,
cover the hole with adhesive tape, then load it
into the VCR.
● The VCR turns on, and the counter is reset,
automatically.
2
Access VCR PLUS+ screen
Press PROG..
3
Access Program screen
Press START +/– once.
4
Set program start time
Press START +/–
repeatedly to enter the
time you want
recording to start.
● Press and hold START
+/– to increase the
time in 30-minute
intervals.
5
Set program stop time
Press STOP +/– repeatedly to enter the time you
want recording to stop.
● Press and hold STOP +/– to increase the time in
30-minute intervals.
6
Set program date
Press DATE +/–. (The current date is displayed on
the screen. The date you enter appears in its
place.)
7
Set channel number
Press CH +/–.
● If you are using a DBS receiver, see
“ATTENTION FOR DBS RECEIVER USERS” on
next page.
● Holding down CH +/– rapidly changes the
channel numbers.
Express Timer
Programing
Turn on the VCR and the TV, and select the AV
mode on the TV.
1
1
2
3
4
5
6
7
8
9
0
VCR TV CABLE/DBS
WEEKLY
0
DAILY (M-F)
8
POWER
9
2 9
3 – 7
DBS
PROGRAM
START
STOP
DATE
– –:– –AM – –:– –AM – –/– –/– –
CH
SUN
– – –
STD (SP)
PRESS (+/–, SP/EP, 8=DAILY
9=WEEKLY) THEN (OK)
PRESS (PROG.) TO END
PROGRAM
START
STOP
DATE
8:00AM – –:– –AM – –/– –/– –
CH
SUN
– – –
STD (SP)
PRESS (+/–, SP/EP, 8=DAILY
9=WEEKLY) THEN (OK)
PRESS (PROG.) TO END