Subsidiary settings, Mode set, Pg. 67) – JVC DR-MH30S User Manual

Page 67: Audio output, 8 analog audio out — stereo / dolby surround, 8 d. range control — normal / wide range / tv mode, 8 output level — standard / low

Advertising

Masterpage:Right0

Filename [DR-MH30EU_10Subsidiary.fm]

Page 67

Thursday, 27 May 2004 12:05

SUBSIDIARY SETTINGS

Various modes of this unit are categorized into menus nested in 2
levels shown in the following table. To change the settings of these
modes, find the desired mode in the menu (for details on each
menu, see pages 67 through 68), then follow the procedure below.

● The procedure below shows how to set the desired option of the

“AUDIO REC” mode as an example.

Press SET UP to access the Main Menu screen.

Press w e to select “FUNCTION SET UP”, then press ENTER.

Press w e to select “REC/PLAY

SET UP”, then press ENTER.

Press rt to select “AUDIO

REC”, then press ENTER.

Press rt to select the desired

option, then press ENTER.

Press SET UP to complete the

setting.

* The boldface settings below indicate the settings at your purchase.

AUDIO OUTPUT

8 DIGITAL AUDIO OUT — DOLBY DIGITAL/PCM / STREAM/

PCM / PCM ONLY

Set to the appropriate mode according to the type of the device
connected to DIGITAL OUT connector.

DOLBY DIGITAL/PCM

: Select this when you connect the digital

input connector of a Dolby Digital decoder or an amplifier with a
built-in Dolby Digital decoder.

STREAM/PCM

: Select this when you connect the digital input

connector of an amplifier with a built-in DTS, Dolby Digital, or
MPEG multichannel decoder.

PCM ONLY

: Select this when you connect the linear PCM digital

input of other audio equipment (amplifier, MD or DAT deck, etc.).

8 ANALOG AUDIO OUT — STEREO / DOLBY SURROUND

Select the appropriate setting to accommodate the unit to the
connected A/V equipment. This function takes effect when a
DVD VIDEO disc is played back.

STEREO

: Select this when listening to conventional two-channel

stereo audio with the unit’s AUDIO OUT connectors connected
to a stereo amplifier/receiver or TV set, or in case you want to
record the audio from a DVD VIDEO disc to a Mini Disc, etc.

DOLBY SURROUND

: Select this when listening to multichannel

surround audio with the unit’s AUDIO OUT connectors
connected to an amplifier/receiver with a built-in surround
decoder or a surround decoder.

8 D. RANGE CONTROL — NORMAL / WIDE RANGE /

TV MODE

The dynamic range (the difference between the loudest sound and
the quietest one) can be compressed during playback of a
programme encoded in Dolby Digital format.
This function takes effect when a DVD VIDEO disc recorded in
Dolby Digital format is played back at low or middle volume.

NORMAL

: Normally select this setting to activate this function.

WIDE RANGE

: Select this to deactivate this function when you

enjoy wide dynamic range programme.

TV MODE

: Select this when you hear the sound through the TV’s

speaker(s).

NOTES:

● This function takes no effect on programmes other than that recorded

in Dolby Digital format.

● This function dose not work when Simulated Surround Effect is