JVC BR-DV6000 - Manual (Page 63)

63
BR-DV6000
PROFESSIONAL RESET A.DUB
EJECT
COUNTER AUDIO INPUT SELECT MONITOR OUTPUT REMOTE
LOCAL
CTL L
MIX
R
CH-1/2
MIX
CH-3/4
DV
LINE
Y/C (CPN)
TC
UB
REW STOP FF
REC
OPERATE
PLAY PAUSE DISP
SET SEARCH+
BLANK CUE UP
REC LEVEL
CH-1/3 CH-2/4
3 2 K C H – 1 / 2 0 m S P i n 0 0
A S S E M
W A R N I N G 7 0 0 1
D R U M MO T O R F A I L U R E
R E C I N H I B I T
0 3 / 0 4 / 0 3 P L A Y
1 1 : 2 0 : 0 0 T C R 0 2 : 0 0 : 0 0 : 0 0
Monitor / LCD (Status display)
VIDEO LINE
IN
OUT
MONITOR
OUT
DC12V
DV
IN/OUT
IN OUT OFF
AUDIO
REMOTE2
IN B-Y R-Y
SYNC IN TIME CODE IN OUT
Y
COMPONENT
OUT CH 1/3 CH 2/4
IN
OUT
MONITOR
OUT REMOTE1 TIMER
REC PLAY
SERIAL
REMOTE SIGNAL GND
Y/C
TIME CODE – Playing back the time code –
BR-DV6000 is also equipped with a time code reader. During playback, the time code or user’s bit
data recorded on the tape is displayed on the monitor or the LCD.
COUNTER switch
TIME CODE OUT terminal
Time code or user’s bit
1.
Select the time code data to display.
Set the COUNTER switch to “TC” or “UB”.
2.
Press the PLAY button to go to the PLAYBACK mode.
¥ It displays the time code and the user’s bit on the monitor or
the LCD. The counter display mode becomes TCR or UBR.
• The LTC time code is output from the TIME CODE OUT terminal
on the rear panel.
❈ The VITC time code is not output.
If the COUNTER switch is set to CTL, the time code is not out-
put.
Caution on time code playback
● During playback, if a portion of tape without recorded time code
runs through, the time code stops running. Playback continues.
● If tapes without recorded user’s bit, e.g. those recorded with a
home-use DV VCR, are played back on BR-DV6000, “– –” is dis-
played.
DV6000U_52-071_Eng.p65e 06/03/03, 11:40 PM 63