JVC CA-V908T - Manual (Page 23)

19
English
Switching between Frequency Bands ———————————
Press FM/AM.
Each time you press the button, the band alternates between FM and AM.
COMPU PLAY
When FM/AM is pressed while the power is on standby, the power is automatically turned on.
Three Ways to Select a Station ——————————————
Press TUNING DOWN or TUNING UP on the MULTI CONTROL repeatedly to move from
frequency to frequency until you find the one you want. (Manual Tuning).
OR
Press and hold TUNING DOWN or TUNING UP on the MULTI CONTROL for a few seconds, the
frequency starts changing on the display. When a station is tuned in, the frequency stops changing.
(Auto Tuning).
OR
Possible only after presetting stations.
Press once and release P. DOWN or P. UP on the MULTI CONTROL to go to the next preset station.
You can also use the remote control to tune in preset channels:
1. Press FM/AM so that you can receive the last station tuned in.
2. Select the station by entering the preset number in the number keys of the remote control.
•
Example: for channel 5, press 5. For channel 15, press +10 then 5.
For channel 20, press +10, then 10. For channel 30, press +10 twice then 10.
• After you have selected the preset number and the number appears, the broadcast frequency of the
selected channel appears on the display.
Presetting Stations
You can preset up to 30 FM stations and up to 15 AM stations for the preset numbers.
Note: In some cases, test frequencies have been already memorized for the tuner since the factory
examined the tuner preset function before shipment. This is not a malfunction. You can preset the stations
you want into memory by following the presetting method.
1. Select a band by pressing FM/AM on the Unit.
2. Press TUNING DOWN or TUNING UP on the MULTI CONTROL to tune
into a station.
3. Press SET.
“SET” flashes for 5 seconds.
While it is still flashing, carry out the following procedure.
4. Press P. DOWN or P. UP on the MULTI
CONTROL on the Unit to set the preset number.
5. Press SET again.
“STORED” appears for 2 seconds. The preset station is
stored in the memory.
6. Repeat steps 1 to 5 for each station you want to store in memory
using different preset numbers.
CAUTION: If the Unit is unplugged or if a power failure occurs, the preset
stations will be erased in a few days. If this happens, preset the station
again.
1
3 , 5
2
4
or
or
or
FM/AM
NEXT
PREV
or
NEXT
PREV
NEXT
PREV
ONSCREEN
TEST TONE
CENTER MODE
DELAY TIME
L BALANCE R
CENTER
LEVEL
3CH LOGIC PRO LOGIC
V.INTRO
– +
REAR
LEVEL
– +
HIGHLIGHT
EN14-20.CA-V908T[U]/f 98.7.22, 8:04 PM 19