Jura Capresso 64701R1 - Manual (Page 16)

• Close the holder for the cartridge so that it engages in the
water tank (Fig.11).
• Fill the water tank with fresh cold water and replace.
You must activate the cartridge as follows:
1. Push and hold the P button (Fig. 3e). FILTER –
2. Push the Dial and the display shows NO –
3. Turn the Dial until the display shows YES
✔
4. Push Dial confirm. The display shows INSERT / OPEN TAP
5. Place a 20 oz. container underneath the frother.
6. Turn the Steam/Water Selector to the water symbol.
FILTER RINSING . For the next 90 seconds the machine will
push water through the filter and through the frother. Do not
interrupt this process. This activates the filter.
The machine will stop automatically.
7. SHUT TAP . Turn the Water/Steam Dial back to the cup symbol.
HEATING . READY .
Please note: As long as the filter is activated, the water
hardness setting is automatically turned off.
16b. REPLACING THE CLEARYL WATER CARTRIDGE
The filter is monitored automatically. After approx. 75 liters of
water (~2,500 oz.), the filter loses its effect. The display changes
from
READY to CHANGE FILTER / MACHINE READY . You can
still make coffee, but we recommend replacing the filter within
one week!
Attention: The filter should be changed every 3 months if you
use less than 75 liters of water. In this case, no message will
appear in the display.
Important: Once the filter has lost its calcium suppressing
abilities, calcium will build up inside the machine. Since the
Water Hardness Selector is off, the machine will not remind you
when to decalcify. This could clog and ruin your machine.
• Remove the old filter. The cartridge is environmentally friendly.
Dispose it with your regular household trash.
• Make sure the water tank is empty.
• Remove the new cartridge from its bag.
• Open water container lid and pull up the holder for the
cartridge (Fig. 9).
• Insert the cartridge with its tapered end down into the water
container. Make sure it fits securely inside the fins. Push down
gently (Fig.10).
• Close the holder for the cartridge so that it engages in the
water tank (Fig.11).
• Fill the water tank with fresh cold water and replace.
1. Push and hold the Rinse Button. The display shows
RINSE
and the Dial is illuminated.
2. Turn the Dial until the display shows FILTER .
3. Push the Dial. The display shows REPLACE OPEN TAP .
4. Place a 20 oz. container underneath the frother.
5. Turn the Steam/Water Selector to the water symbol.
FILTER RINSING
For the next 90 seconds the machine will push water through
the filter and through the frother. Do not interrupt this process.
This activates the filter. The machine will stop automatically.
6. SHUT TAP . Turn the Water/Steam Dial back to the cup symbol.
HEATING . READY .
17. ADJUSTING THE WATER HARDNESS
Water is heated inside the machine. With use, this leads to
calcium deposits forming inside the machine. The display will
16.