Jura Capresso 64701R1 - Manual (Page 20)

• Place a cup underneath the frother.
• Push and hold the Steam Button until the display shows:
OPEN TAP . Turn the Steam/Water Selector to the water symbol.
The machine will push a bit of water and steam into the cup
underneath the frother.
• When display shows CLOSE TAP turn the Steam/Water Selector
back to the cup symbol. The machine will automatically shut off.
Important: The next time you turn the machine on you must
follow the instructions in chapter 6.
Please note: Before transporting the machine, make sure that
the water tank is empty, the filter cartridge is removed (discard
and use a new cartridge), the bean container is empty, the
drawer and used coffee container are empty and clean.
Secure the lids of the water tank and the bean container with
scotch tape. Pack entire machine with thick cushioning material
on all sides to prevent damage.
20. AUTOMATIC CLEANING CYCLES
20a. RINSING
You can run an extra hot water rinse cycle as follows.
•
READY . Push and hold the Rinse button until display shows
RINSE . The Dial illuminates.
• Push the Dial. Hot water is dispersed through the coffee
spouts and will stop automatically. READY .
20b. CLEANING WITH SPECIAL TABLET
The machine monitors how many coffees are brewed and how
often the rinsing program is activated. After approx. 200 coffees
the display will show
CLEAN MACHINE / MACHINE READY .
Please note: You can continue making coffee, however we
highly recommend that you clean the machine as described
below within the next few days. This cleaning program will
remove oil build-ups in the brewing chamber. The cleaning pro-
gram takes about 15 minutes. Please use one white cleaning
tablet (enclosed). The machine comes with a pack of 2 tablets.
To re-order cleaning tablets see chapter 22.
Important: Once the cleaning program has started do not
interrupt the procedure.
1.Make sure the machine is on and the water tank is full.
2.Push the Rinse button. The display shows
EMPTY DRAWER .
3.Remove and empty the drawer and used coffee container and
replace complete assembly (Fig. 21).
Important: Even if the drawer and the used coffee container are
empty, you still need to remove the drawer for approx. 20 seconds
and then replace it. The display shows
PRESS RINSE .
4.Place a 12 oz. container under the coffee spouts.
5.Push the Rinse button. The display shows
CLEANING .
After a moment the display shows ADD TABLET/ PRESS RINSE .
6.Open the ground coffee lid and drop in one white cleaning
tablet (Fig. 22). Your machine comes with a pack of two
tablets. To order more tablets see chapter 22 "Supplies".
7.Push the Rinse button. The display shows CLEANING .
The cleaning program will dispense hot foamy water in
intervals through the coffee spout into the drawer.
8.When finished, the display shows EMPTY DRAWER .
9.Lift and remove the drawer. Empty the used coffee container
and drawer and replace. The display shows READY indicating
the machine is now ready to brew coffee again.
Attention: You can run a tablet cleaning cycle at anytime even if
20.