JL Audio Stealthbox SB-T-CAM/12W3v3 - Manual (Page 2)

Continued on Next Page
SB-T-CAM/12W3V3 INSTR_SKU# 011284
s t e P 7
Align the jack so that the bolt that secures the spare can be
re-inserted thru the wheel and, jack thereby securing both in
the spare tire well.
s t e P 6
Use the strap that was removed in steP 4 to secure the jack
to the spare wheel.
s t e P 5
Remove the spare tire and turn it over. Put the jack inside
the wheel and, expand it so that the pressure from the jack
holds it in place.
s t e P 4
Remove the strap that secured the Jack to the locating foam,
this will be re-used to secure the jack to the spare tire.
Page 2 • JL Audio, Inc 2008
S T E P 9
Remove the trunk liner fastening plug, this will be replaced
by one of 1/4-20 Rivet Nuts (see detailed picture of the Rivet
Nut below). Enlarge the hole using a 3/8” drill bit and, drill.
*CAUTION*
Before drilling, always make sure that you are not
going to be drilling into any gas lines, brake lines,
transmission lines, electrical wiring, exhaust systems
or anything else that might cause a reduction in
your weekly pay. always wear eye protection when
drilling.
S T E P 1 1
The anchor point for the cargo net needs to be removed for
the installation of the Stealthbox®.
S T E P 1 0
Insert the 1/4-20 Rivet Nut into the appropriate hole and,
expand it by tightening a 1/4-20 x 5/8” Pan Head Phillips
Screw, once the 1/4-20 Rivet Nut has been expanded in
place, remove the 1/4-20 x 5/8” Pan Head Phillips Screw. The
procedure for installing the Rivet Nuts will be repeated three
times in total
(stePs 9 & 15) as will be detailed.
S T E P 8
Re-install both floor panels that were removed in steP 2.
Install both of the brackets on the bottom of the enclo-
sure as shown