JL Audio Stealthbox SB-T-CAM/12W3v3 - Manual (Page 3)

Continued on Next Page
SB-T-CAM/12W3V3 INSTR_SKU# 011284
s t e P 1 5
Using a drill with a 3/8” bit, drill through the locations marked
in steP 14 . Repeat steP 10 in both holes.
*CAUTION*
Before drilling, always make sure that you are not
going to be drilling into any gas lines, brake lines,
transmission lines, electrical wiring, exhaust systems
or anything else that might cause a reduction in
your weekly pay. always wear eye protection when
drilling.
s t e P 1 4
Press in at the bottom of the enclosure so that it sits as tight
in the side as possible, and mark the locations for the bottom
anchors to be drilled through the floor. Remove the enclo-
sure from the side.
s t e P 1 3
The two lower brackets from the Stealthbox® should be con-
figured as shown, the one that goes up will be the same, just
arranged vertically.
s t e P 1 2
Attach the upper mounting bracket into the just installed
1/4-20 Rivet Nut using One of the supplied 1/4-20 Phillips
Head Screws. The correct order of the hardware is indicated
in the illustration below.
Page 3 • JL Audio, Inc 2008
S T E P 1 7
C o n G R a t u l a t I o n s !
You have completed the installation for this model!
Enjoy your new Stealthbox®!
Please refer to the Power Recommendation section for an
amplifier recommendation and basic set-up help.
S T E P 1 6
Test the Stealthbox® to ensure proper operation then,
remount using the supplied three Phillips Head Screws, Split
Lock Washers and, Flat Washers.
THREADED INSERT FLAT WASHER
HEX BOLT
LOCK WASHER
MOUNTING BRACKET
LOCK WASHER
STEALTHBOX®
VEHICLE BODY
RIVET NUT
PHILLIPS HEAD SCREW