JBL SUB12 - Manual (Page 5)

SYSTEM CONNECTIONS
If you have a Dolby ® Digital or DTS ® receiver/processor with a
low-frequency-effects (LFE) or subwoofer output:
If your receiver/processor does not have subwoofer outputs
for the left and right channels or an LFE output, connect
speaker wire from your receiver/amplifier to your speakers
and subwoofer using two sets of speaker wire:
5
If your receiver/processor does not contain a Dolby Digital
or DTS processor, but has subwoofer outputs:
Set line-level/LFE switch to
“Normal.”
NOTE: If your receiver/processor
has only one sub out, you may
use either the L or R input.
CROSSOVER
FREQUENCY
LEVEL
LINE LEVEL IN
PHASE
Min Max
L
R
L R
For LFE use L or R
LFE NORMAL
HIGH
LEVEL
IN
50Hz
0º 180º
150Hz
RECEIVER/AMPLIFIER
Front Speaker Output
80Hz
Green: On
Red: Standby
PS-10/PS-12
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
120V
60Hz
CROSSOVER
FREQUENCY
LEVEL
LINE LEVEL IN
PHASE
Min Max
L
R
L R
For LFE use L or R
LFE NORMAL
HIGH
LEVEL
IN
+ –
50Hz
0º 180º
150Hz
POWER
ON OFF
RECEIVER/PROCESSOR
80Hz L R
Green: On
Red: Standby
PS-10/PS-12
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
120V
60Hz
CROSSOVER
FREQUENCY
LEVEL
LINE LEVEL IN
PHASE
Min Max
L
R
L R
For LFE use L or R
LFE NORMAL
HIGH
LEVEL
IN
L
R
HIGH
LEVEL
OUT
+ –
50Hz
0º 180º
150Hz
POWER
ON OFF
SUBWOOFER OR
LFE OUTPUT
80Hz
Green: On
Red: Standby
Set LFE/Normal switch to “LFE.”
This figure shows how to connect bare wires to the terminals.
Venue Sub OM 1/27/06 9:26 AM Page 7