JVC GET0471-001A - Manual (Page 19)

ENGLISH
19
Other external component
operations
You can connect an external component to the LINE IN
plugs on the rear, and another to the CD changer jack
on the rear using the Line Input Adapter—KS-U57
(not supplied) or AUX Input Adapter—KS-U58 (not
supplied).
• For connection, see Installation/Connection Manual
(separate volume).
• For listening to the iPod or D. player, refer to pages
17 and 18.
~
If “EXT IN” does not appear, see page 16 and
select the external input (“EXT IN”).
Ÿ
Turn on the connected component and
start playing the source.
!
Adjust the volume.
⁄
Adjust the sound as you want. (See
page 14.)
To check the other information while
listening to an external component
Clock
Ô EXT IN or LINE IN
Maintenance
How to clean the connectors
Frequent detachment will deteriorate the connectors.
To minimize this possibility, periodically wipe the
connectors with a cotton swab or cloth moistened with
alcohol, being careful not to damage the connectors.
Moisture condensation
Moisture may condense on the lens inside the unit in
the following cases:
• After starting the heater in the car.
• If it becomes very humid inside the car.
Should this occur, the unit may malfunction. In this
case, eject the disc and leave the unit turned on for a
few hours until the moisture evaporates.
How to handle discs
When removing a disc from its
case, press down the center holder of
the case and lift the disc out, holding
it by the edges.
• Always hold the disc by the edges. Do not touch its
recording surface.
When storing a disc into its case, gently insert the
disc around the center holder (with the printed surface
facing up).
• Make sure to store discs into the cases after use.
Center holder
Connector
Continued on the next page
EN14-19_SV3305_007A_f.indd 19 EN14-19_SV3305_007A_f.indd 19 1/24/07 11:25:23 AM 1/24/07 11:25:23 AM