Sanyo PJ-NET ORGANIZER POA-PN10 - Manual (Page 22)

22
Installation
Windows XP
This example explains how to set the following network address.
1
Select the Control Panel menu from the
[Start] menu. Click the Network and Internet
Connection and then click the Network on the
control panel.
2
Click the Local Area Connection icon with
right button of the mouse and then select the
Property menu. The right window will appear
on the screen.
3
Select the General tab on the "Local Area
Connection Properties" dialog window. Select
the Internet Protocol(TCP/IP)
*1 and then press
the Properties button.
4
On the "Internet Protocol (TCP/IP) Properties"
dialog window, select the Use the following
IP address button and then enter the IP
address*
2 and Subnet mask.
5
Enter the Default gateway address.
✐ This setting is not needed if the network does
not provide the gateway (router).
6
Click the OK button, the setting window will
be closed.
✐ To change the configuration, you may need admin-
istrator privileges.
IP Address : 192.168.0.5
Subnet Mask : 255.255.255.0
Gateway Address : 192.168.100.1
*1 Select the "TCP/IP" item of the LAN card you use. If the "TCP/IP" item is not listed in the col-
umn, you need to install the TCP/IP protocol. For further information refer to the user's man-
ual of your computer.
*2 If the network already has the TCP/IP protocol set, enter with the same IP network number
for the IP address and Subnet mask.
*3 There are some ways to set up the network depending on your computer’s appearances.