Sony HT-SS100 - Manual (Page 14)

14 GB
You can install your speakers on the wall.
1
Prepare screws (not supplied)
that are suitable for the hook on
the back of each speaker. See
the illustrations below.
2
Fasten the screws to the wall.
The screws should protrude
5 mm to 7 mm.
For the center speaker
For the front speakers of HT-SF100
For the surround speakers of HT-SF100
For the front speakers and surround
speakers of HT-SS100
3
Hang the speakers on the
screws.
Notes
• Use screws that are suitable for the wall material
and strength. As a plaster board wall is especially
fragile, attach the screws securely to a beam and
fasten them to the wall. Install the speakers on a
vertical and flat wall where reinforcement is
applied.
• Contact a screw shop or installer regarding the
wall material or screws to be used.
• Sony is not responsible for accident or damage
caused by improper installation, insufficient wall
strength or improper screw installation, natural
calamity, etc.
• For HT-SF100, if you install the speakers on the
wall, you do not need to attach the supplied
speaker stand.
Installing the speakers on the
wall
4 mm
more than 25 mm
4.6 mm
10 mm
Hook on the back of the speaker
5 mm to 7 mm
160 mm
5 mm to 7 mm
217 mm
5 mm to 7 mm
100 mm
5 mm to 7 mm
4.6 mm
10 mm
Rear of speaker