Soundstream Technologies XXX-15000D - Manual (Page 9)

POWER
[GREEN]
PROTECT
[RED]
GND GND
8.Gnd[Chassis ground)
7. LED indicatior
8
POWER : This GREEN LED will illuminate when the amplifier is turned“ON”. If it fails to illuminate check
the power connections to the amplifier and fuses.
PROTECT : The amplifier protection circuitry will disable the amplifier if input overload, short circuit or
extremely high temperature conditions are detected. when the protection mode is in operation
the red LED indicator on the side panel will be illuminated the amplifier has gone into a self-preservation
mode.
If you observe that the protection LED is lit, please check the system carefully to determine what has
caused the protection circuit to engage. the amplifier can be reset by turning the remote power off
and then on again. If the amplifier shut down due to a thermal overload condition. please allow it to
cool down before restarting. If the amplifier shut down of an input overload or short circuit .be sure
to repair these conditions before attempting to power up the amplifier again.
To avoid unwanted ignition noise caused by ground loops. It is essential that the amplifier be grounded
to a clean, bare, metal surface of the vehicles chassis.
It is not recommended to use seat or seat belt bolts..