Sterling Power Products DAI-1500C-24xx - Manual (Page 20)

-17-
F. Disabling Functions ( Fn05)
Each different function, charger, inverter and transfer can be disabled. This is
useful for specific applications which are required to disable some of these three
functions. If you press the “FUNC” button for more than 2 seconds you can
have access to the different possibilities shown in the following diagram,.
In programming mode the display only shows the different types of program with
the “Charger”, Transfer” and “Inverter” functions. To change the type of
programming press the “
△ or ▽ ” button until the LED corresponding to the
desired function is lit, in to the table below, After 10 seconds or press “DSPL”
button the Invertek will exit the programming mode and function with the new
programming,. In normal user mode, the disabled functions are displayed by a
orange blinking LED.