Sanyo PLC-WXU30 - Manual (Page 55)

55
Setting
Change the PIN code lock setting
Use the Point 7 8 buttons to
switch between the options.
Use the Point 7 8 buttons to select Off, On1, or On2 and
then move the pointer to “Quit” with the Point d button.
Press the SELECT button to close the dialog box.
Change the PIN code lock setting
Enter a PIN code
Use the Point ed buttons to enter a number. Press the
Point 8 button to fix the number and move the red frame
pointer to the next box. The number changes to “✳.” If you
fixed an incorrect number, use the Point 7 button to move
the pointer to the number you want to correct, and then
enter the correct number.
Repeat this step to complete entering a four-digit number.
After entering the four-digit number, move the pointer to
“Set.” Press the SELECT button so that you can start to
operate the projector.
If you entered an incorrect PIN code, “PIN code” and the
number (✳✳✳✳) will turn red for a moment. Enter the
correct PIN code all over again.
Enter a PIN code
After a correct PIN code is
entered, the following dialog
box appears.
The PIN code can be changed to your desired four-
digit number. Press the Point d button to select “PIN
code change” and press the SELECT button. The New
PIN code input dialog box appears. Set a new PIN code.
Change the PIN code
Change the PIN code
CAUTION:
WHEN yOU HAVE CHANGED THE PIN CODE, WRITE
DOWN THE NEW PIN CODE IN COLUMN OF THE
PIN CODE NO . MEMO ON PAGE 80, AND KEEP IT
SECURELy . IF yOU FORGET yOUR PIN CODE, THE
PROjECTOR CAN NO LONGER BE STARTED .
Alarm
This function allows you to configure the Alarm
operation. See “How to Use the Antitheft Alarm Function”
on pages 58–60.