Seiko Instruments V-64S - Manual (Page 18)

6 6
Stain
pattern
2
Cause
Ink drooling
Solution Solution Follow the procedures below.
*Clean the media edge guards when ink accumulated on them.
 Check that no wrinkles or rising exists on the media or that the media is
slantingly set. Set the media again.
Refer to the solutions for White lines pattern 4.
 Check that the Print head height is at [HIGH] and then confirm that the
symptom is improved. ( P.2-44 Change the Print head height)
 Perform the daily maintenance and confirm that the symptom is
improved. ( P.4-3 Regular Inspection / Maintenance (Daily maintenance))
 Perform the Print head cleaning [NORMAL ALL]. Perform [NOZZLE PRINT]
and confirm that the symptom is improved.
( P.4-19 Print head cleaning, P.4-8 Performing the nozzle print)
 Select [RESEAT PRINTHEAD] on the operation panel and move the
carriage. After cleaning the print head nozzle surface, perform [NOZZLE
PRINT] and confirm that the symptom is improved.
( P.5-23 Cleaning of Print head surface, P.4-8 Performing the nozzle print)
HINT
To clean the print head nozzle surface, wipe the print head surface back and
forth lightly, while visually checking, with a Cleaning swab soaked with cap
cleaning liquid.
When print continues with the color stripe [OFF], the above symptom may occur.
Normally, print with the color stripe [ON].
–
–
–
Stain on the print..."
Stain
pattern 2" 