Sharp PG-C20XU - Manual (Page 37)

E-36
Useful Features
Reverse/Invert Image Function
This projector is equipped with a reverse/invert image
function which allows you to reverse or invert the pro-
jected image for various applications.
Description of Projected Images
Projector Remote control
(GUI) On-screen Display
Selected item
Front
Ceiling םFront
Rear
Ceiling םRear
Projected image
Normal image
Inverted image
Reversed image
Reversed and inverted image
1 Press MENU.
2 Press ∂/ƒ to select “PRJ Mode”, and then press
ENTER.
3 Press ∂/ƒ to select the desired projection mode,
and then press ENTER.
4 To exit from the GUI, press MENU.
• This function is used for the reversed image and ceiling-
mount setups. See page 19 for these setups.
ON/OFF
POWER
LAMP
TEMP.
KEYSTONE
INPUT
BACK ENTER MENU
AUTO SYNC
2, 3
2, 3
1, 4
Ordinarily, the type of input signal is detected and the
correct resolution mode is automatically selected.
However, since the projector cannot distinguish
640
ן480 signal resolution on computers or 480P on
DTVs, select an appropriate mode on “Special Modes.”
1 Press MENU.
2 Press ∂/ƒ to select “Special Modes”, and then
press ENTER.
3 Press ∂/ƒ to select the optimal resolution mode.
4 Press ENTER to save the setting.
5 To exit from the GUI, press MENU.
• When inputting DTV 480P signals, select “480P” in step 3
above.
Projector Remote control
(GUI) On-screen Display
Special Mode Adjustment
ON/OFF
POWER
LAMP
TEMP.
KEYSTONE
INPUT
BACK ENTER MENU
AUTO SYNC
2, 3
2, 4
1, 5