Sanyo STK-RCS-7TWSUA - Manual (Page 20)

■ Parts supplied with the remote controller
See Table 1.
■ Remote controller installation guidelines
• Mount the remote controller 3.3 to 4.9 ft. (1 to 1.5
meters) off the floor where it can sense the average
temperature of the room.
• Do not mount the remote controller in a place
exposed to direct sunlight or where it is exposed to
outside air such as near a window.
• Do not mount the remote controller behind a curtain or
other object so that it is separated from the air circula-
tion of the room.
• Mount the remote controller inside the room being air
conditioned.
Installation location
Room temperature sensors are separately incorporated in both the indoor unit and the remote controller. Either sensor can
be used to sense the room temperature. The indoor unit sensor is usually used.
If you wish the remote controller to sense the room temperature, press the SENSOR button with a ballpoint pen or tool with
a small tip. (Refer to Fig. 9 on page 4 to locate the SENSOR button.)
■ How to install the remote controller
• The remote controller is set to “Cool/Dry/Heat model” at
the time of shipment from the factory. If the purchased air
conditioner is a COOL/DRY model, follow the instructions
on the label and change the switch on the reverse side of
the remote controller unit to “Cool/Dry model”. (Fig. 1)
• The remote controller is also set to “Single” at the time of
shipment from the factory. For multiple use, set the
switch on the reverse side of the remote controller unit to
“Multi”. (Fig. 1)
• After all work is completed, if any switches have been
changed, then be sure to press the ACL (Reset) button.
(Refer to Fig. 9 on page 4 to locate the ACL (Reset) but-
ton.)
IMPORTANT
Switching the room temperature sensor
Q'ty Q'ty
1
Parts
Wired
remote
controller
Machine
screws
Tapping
screws
2
2
2 Spacers
1
Parts
1
1
Instruction
manual
Figure Figure
Installation
Instructions
Wire
harness
5/32 15/16"
5/32 15/16"
(4 25mm)
(4 25mm)
26.2 ft. (8m)
Table 1
85264190 481 001 © SANYO 2009
INSTALLATION INSTRUCTIONS
• In order to install this wired remote controller onto a wall-mounted model, the connection kit
(STK-KCW1), which must be purchased separately, is required.
• Once the wired remote controller is connected, the wireless remote controller cannot be used.
IMPORTANT
SANYO Commercial Solutions In Canada
A Division of SANYO North America Corporation SANYO Canada Inc.
1300 Michael Drive, Suite A 1-300 Applewood Crescent, Concord
Wood Dale, IL 60191, U.S.A. Ontario, L4K 5C7, Canada
W
Fig. 1
09-027 STK-RCS-7TWSUA 3/10/09 12:46 PM Page 1