Sharp TL-M4600 - Manual (Page 15)

3
Preparation
How to Install the Monitor
Mounting precautions
• Mounting the monitor on the wall requires special expertise and the work must be performed by an
authorized SHARP dealer. You should never attempt to perform any of this work yourself. Our company
will bear no responsibility for accidents or injuries caused by improper mounting or mishandling.
• This monitor is designed to be installed on a concrete wall or pillar. Reinforced work might be necessary
for some materials such as plaster / thin plastic board / wood before starting installation.
This monitor and bracket must be installed on a wall which can endure at least 4 times or more the weight
of the monitor. Install by the most suitable method for the material and the structure.
• This monitor can not be installed in a vertical orientation.
• Since the monitor is heavy, consult your dealer before installing, removing or moving the monitor.
• When installing, removing or moving the monitor, ensure that this is carried out by at least  people.
• When moving the monitor, be sure to hold it with the handles both on the rear and the unit bottom. Do not
hold the LCD panel. This may cause product damage, failure, or injury.
• This monitor should be used at an ambient temperature between 3°F (0°C) and 04°F
(40°C). Provide enough space around the monitor to prevent heat from accumulating inside.
• Do not block any ventilation openings. If the temperature inside the monitor rises, this could lead to a
malfunction.
• Do not place the monitor on a device which generates heat.
Attaching the setup stand
Before performing work spread cushioning over the base area to lay the monitor on. This will prevent it from
being damaged.
Caution
• Please note that the setup stand is for temporary use only until the monitor is properly mounted.
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation of the stand may result in the monitor falling over.
Remove the protective covers from the underside
of the monitor.
1 2
Put the caps on the screws that have been
screwed into the stand.
Assemble the stand using the 6 screws.
3 4
Confirm that there are 0 screws and 6 caps
supplied with the stand.