Sharp TL-M4600 - Manual (Page 52)

50
Specifications
n Power management
This monitor conforms to VESA DPMS and DVI DMPM. Both your video card and computer must support
the same standard in order for the monitor’s power management function to work.
DPMS: Display Power Management Signaling
DPMS Screen Power consumption Hsync Vsync
ON STATE Display
3 W (TL-M500)
78 W (TL-M4600)
Yes Yes
STANDBY
No
display
.7 W* No No
DMPM: Digital Monitor Power Management
DMPM Screen Power consumption
Monitor ON Display
3 W (TL-M500)
78 W (TL-M4600)
Active OFF No display .9 W*
* When “Standby Mode” is set to “Mode”.
33 W when “Standby Mode” is set to “Mode”.
(TL-M500)
30 W when “Standby Mode” is set to “Mode”.
(TL-M4600)
n DDC (plug and play)
The monitor supports the VESA DDC (Display Data Channel) standard.
DDC is a signal standard for plug and play between monitors and computers. Information about resolution
and other parameters is exchanged between the two. This function can be used if the computer supports
DDC and it has been configured to detect plug-and-play monitors.
There are several types of DDC, depending on the communication method used. This monitor supports
DDCB.
n Connecting pin assignments
DVI-D input terminal: DVI-D 4 pin
Pin No. Signal Pin No. Signal
 T.M.D.S data - 3 Not connected
 T.M.D.S data + 4 +5 V power
3 T.M.D.S data /4 shield 5 GND
4 Not connected 6 Hot plug detection
5 Not connected 7 T.M.D.S data 0-
6 DDC clock 8 T.M.D.S data 0+
7 DDC data 9 T.M.D.S data 0/5 shield
8 Not connected 0 Not connected
9 T.M.D.S data -  Not connected
0 T.M.D.S data +  T.M.D.S clock shield
 T.M.D.S data /3 shield 3 T.M.D.S clock+
 Not connected 4 T.M.D.S clock-
RS-232C terminal: D-sub 9 pin
Pin No. Signal Pin No. Signal
 Not connected 6 Not connected
 Received data 7 Request to Send
3 Transmitted data 8 Clear to Send
4 Not connected 9 Not connected
5 GND