Silicon Laboratories C8051F347 - Manual (Page 96)

C8051F340/1/2/3/4/5/6/7/8/9/A/B/C/D
96 Rev. 1.3
SFR Definition 9.13. IT01CF: INT0/INT1 Configuration
Bit7: IN1PL: INT1 Polarity
0: INT1 input is active low.
1: INT1 input is active high.
Bits6–4: IN1SL2–0: INT1 Port Pin Selection Bits
These bits select which Port pin is assigned to INT1. Note that this pin assignment is inde-
pendent of the Crossbar; INT1 will monitor the assigned Port pin without disturbing the
peripheral that has been assigned the Port pin via the Crossbar. The Crossbar will not
assign the Port pin to a peripheral if it is configured to skip the selected pin (accomplished by
setting to ‘1’ the corresponding bit in register P0SKIP).
Bit3: IN0PL: INT0 Polarity
0: INT0 interrupt is active low.
1: INT0 interrupt is active high.
Bits2–0: INT0SL2–0: INT0 Port Pin Selection Bits
These bits select which Port pin is assigned to INT0. Note that this pin assignment is inde-
pendent of the Crossbar. INT0 will monitor the assigned Port pin without disturbing the
peripheral that has been assigned the Port pin via the Crossbar. The Crossbar will not
assign the Port pin to a peripheral if it is configured to skip the selected pin (accomplished by
setting to ‘1’ the corresponding bit in register P0SKIP).
R/W R/W R/W R/W R/W R/W R/W R/W Reset Value
IN1PL IN1SL2 IN1SL1 IN1SL0 IN0PL IN0SL2 IN0SL1 IN0SL0 00000001
Bit7 Bit6 Bit5 Bit4 Bit3 Bit2 Bit1 Bit0 SFR Address:
0xE4
Note: Refer to SFR Definition 21.1 for INT0/1 edge- or level-sensitive interrupt selection.
IN1SL2–0 INT1 Port Pin
000 P0.0
001 P0.1
010 P0.2
011 P0.3
100 P0.4
101 P0.5
110 P0.6
111 P0.7
IN0SL2–0 INT0 Port Pin
000 P0.0
001 P0.1
010 P0.2
011 P0.3
100 P0.4
101 P0.5
110 P0.6
111 P0.7