Sunrise Medical Kid Kart Xpress - Manual (Page 37)


mkt3048 9921700000 Rev C
BB. hIp pADs (OpTIONAL)
Hip pads are optional equipment available only with
the optional contoured seating system.
Width Adjustment
1. Determine the proper location for each hip pad.
2. Remove the back cushion to expose hip pad
adjustment screws.
3. Loosen two adjustment screws for each hip pad just
enough to allow adjustment.
4. Adjust hip pads to the desired position.
5. Tighten the adjustment screws and replace the back
cushion. (See Fig. 34)
Note: Hip pad hardware must be removed for hip
widths greater than 10". The foam hip pad attaches
beneath fabric at seat back to seat base pivot point to
accommodate 11" hip width.
CC. KNee ADDUCTORs (OpTIONAL)
Knee adductors are optional equipment available only
with the optional contoured seating system.
Angle and Width Adjustment
1. Locate knee adductor adjustment screws. Screws are
located beneath the forward edge of the seat. Seat
cushion removal aids greatly in finding screw location.
2. Lock wheels, seat child, and buckle the pelvic
positioning belt.
3. Loosen two adjustment screws from beneath the seat
and adjust knee adductor to proper width and angle.
(See Fig. 35)
4. Tighten adjustment screws to lock adductor position.
5. Repeat adjustment sequence on opposite knee
adductor.
Figure 34
Figure 35
V I I . O p e R A T I N G I N s T R U C T I O N s