Speco Technologies P120FACD/P240FACD - Manual (Page 7)

PUBLIC ADDRESS AMPLIFIER
5 P120FACD/P240FACD
Front Panel Front Panel
1. POWER SWITCH
Pressing this switch turns the unit on, and the VFD (Vacuum Fluorescent Display) will show the status of the
unit. Pressing again will turn the unit off. If the AC power is connected, the unit will enter Standby mode, and
the “POWER” LED will light.
When the protection circuitry is activated, the “POWER” LED will blink.
This indicates that the unit is not operating normally. This is typically due to rare cases of overheating, over-
load or output line shorts. Please check the input and output conditions of the amplifier in this event. The
unit will automatically turn the power on and check the protection state 1 minute after the protection
circuitry has been activated. If you want to release the protection manually, press the POWER switch.
2. SPEAKER SELECTOR
These switches are used to select speaker output zones. The “All” button will select all speaker zones (SP1,
SP2, SP3, SP4 and SP5). 8Ω output is not controlled by the speaker selector buttons.
3. DIMMER BUTTON
Press this button to change the brightness of the display.
4. FM /CD/AUX BUTTON
1) FM MUTE Button
This button can be used to mute the FM output while searching for a station with a good signal.
2) FM/CD/AUX select button
This button will allow you to toggle between the 3 possible sources.
3) REPEAT Button
Press this button to repeat a track or tracks on a CD.
4) GROUP Button
Press this button to select a folder on an MP3 disk.
5) RANDOM Button
Press this button to randomly play CD tracks.
15 16 17 18 14 13 12 11
3 4 7 8 9 10 1 2 5 6