SUUNTO 110.9772 - Manual (Page 15)

15
12. Select a Timed Dry heated cycle, and start the dryer. Do not
select the Air Only Temperature setting.
If the dryer will not start, check the following:
■ Dryer is plugged into a grounded 3 prong outlet.
■ Electrical supply is connected.
■ Household fuse is intact and tight, or circuit breaker has
not tripped.
■ Dryer door is closed.
This Dryer automatically runs an installation diagnostic routine at
the start of its first cycle.
If you receive an L2 code, there may be a problem with your
home power supply keeping the dryer’s heater from turning
on. See “Troubleshooting.”
If you receive an AF code, your dryer vent may be crushed or
blocked. See “Troubleshooting.”
NOTE: You may notice a burning odor when the dryer is first
heated. This odor is common when the heating element is first
used. The odor will go away.
DRYER USE
Starting Your Dryer
Follow these basic steps to start your dryer. Please refer to
specific sections of this manual for more detailed information.
1. Clean lint screen before each load. See “Cleaning the Lint
Screen.”
2. Place laundry in dryer and shut door.
3. Press the POWER button. Then rotate the dial to select the
desired Auto or SteamCare Cycle. Press button on left of dial
to select the desired Timed Cycle. The indicator light for the
selected Auto or Timed Cycle will glow green. The indicator
light for the selected SteamCare Cycle will glow blue. The
preset modifiers for the selected cycle will glow green.
Selectable options will glow amber. If an option or modifier is
unavailable with the selected cycle, the light will not
illuminate. The estimated or actual cycle time (in minutes) will
show in the display.
To use an Auto Cycle
NOTE: A light next to each feature will glow green when the
feature is selected or will glow amber when the feature is
selectable.
■ Select an Auto Cycle.
■ Select DRYNESS LEVEL to adjust how dry you want the
load. As the cycle runs, the control senses the dryness of
the load and adjusts the time automatically for the
selected dryness level.
NOTE: Most loads may be dried using the Normal
dryness level, which is shown in bold letters on your
control panel. Normal is the energy preferred dryness
level and will use the least energy.
■ Select the desired Options.
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Do not dry anything that has ever had anything
flammable on it (even after washing).
Failure to follow these instructions can result in death,
explosion, or fire.
WARNING
Fire Hazard
No washer can completely remove oil.
Do not dry anything that has ever had any type of oil on
it (including cooking oils).
Items containing foam, rubber, or plastic must be dried
on a clothesline or by using an Air Cycle.
Failure to follow these instructions can result in death
or fire.