SUUNTO 110.9772 - Manual (Page 21)

21
3. Place wet items on top of the dryer rack. Allow space around
items for air to circulate. The dryer rack does not move, but
the drum will rotate. Make sure items do not hang over the
edges or between dryer rack grille.
4. Close the door.
5. Select Rack Dry or Timed Dry/Air Dry cycle. Items containing
foam, rubber or plastic must be dried on a clothesline or by
using the Timed Dry/Air Dry cycle. Refer to the following
table.
6. When these cycles are selected, the Estimated Time
Remaining display shows the default time. You can change
the actual time in the cycle by pressing More Time or Less
Time.
7. Start the dryer.
NOTE: Check the lint screen and remove any lint accumulated
from items dried on the dryer rack after the cycle is finished.
*Reset cycle to complete drying if needed.
NOTE: You must remove dryer rack for normal tumbling. To
remove the dryer rack, lift it straight up and out of the dryer.
DRYER CARE
Cleaning the Dryer Location
Keep dryer area clear and free from items that would obstruct the
flow of combustion and ventilation air.
Cleaning the Lint Screen
Every load cleaning
The lint screen is located in the door opening of the dryer. The
control panel has an indicator light to remind you to clean the lint
screen before or after each load. A screen blocked by lint can
increase drying time.
To clean
1. Pull the lint screen straight up. Roll lint off the screen with
your fingers. Do not rinse or wash screen to remove lint. Wet
lint is hard to remove.
2. Push the lint screen firmly back into place.
IMPORTANT:
■ Do not run the dryer with the lint screen loose, damaged,
blocked, or missing. Doing so can cause overheating and
damage to both the dryer and fabrics.
■ If lint falls off the screen into the dryer during removal, check
the exhaust hood and remove the lint. See “Venting
Requirements.”
As needed cleaning
Laundry detergent and fabric softener residue can build up on the
lint screen. This buildup can cause longer drying times for your
clothes, or cause the dryer to stop before your load is completely
dry. The screen is probably clogged if lint falls off the screen.
Clean the lint screen with a nylon brush every 6 months, or more
frequently, if it becomes clogged due to a residue buildup.
To wash
1. Roll lint off the screen with your fingers.
2. Wet both sides of lint screen with hot water.
3. Wet a nylon brush with hot water and liquid detergent. Scrub
lint screen with the brush to remove residue buildup.
4. Rinse screen with hot water.
5. Thoroughly dry lint screen with a clean towel. Replace screen
in dryer.
Dryer Rack Cycle Temp. Time*
Wool Sweaters
Block to shape and lay flat
on the dryer rack
Rack Dry Low 60
Stuffed toys or pillows
Cotton or polyester fiber
filled
Rack Dry Low 60
Stuffed toys or pillows
Foam rubber filled
Timed Dry Air Dry
(no heat) 90
Sneakers or canvas
shoes Timed Dry Air Dry
(no heat) 90
WARNING
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from dryer.
Place dryer at least 18 inches (46 cm) above the floor
for a garage installation.
Failure to do so can result in death, explosion, or fire.