Sanus Systems Motorized Mount LA112 - Manual (Page 12)

6901-100189 <01>
7: Route Cables
For Power Outlets Located Outside the Bellows
Route the AV cables [a] over the bottom cross bar, through one of the cable loops [B], then through the
cable access port at the back of the arm assembly. Route the power cord [07] over the bottom cross bar,
through the opposite cable loop [B], then through the cable access port at the bottom of the arm assembly.
Disconnect the plug end of the IR receiver cable [06] and route the cable over the bottom cross bar, through
one of the cable loops [B], then through the access port at thebottom of the arm assembly.
Secure the cables to the bottom cross bar with cable ties [26] as shown. Be sure to keep all cables at least
5cm (2 in.) away from the center beam!
Check that the cables are long enough to allow free movement of the arm assembly, but are not long
enough to get caught in the mechanical parts of the arm assembly. Using the remote, adjust the arm up,
down, and side to side through its full extension. Secure the cables to the cable bar [C] at the back of the
arm assembly.
Avoid potential property damage! Keep all cables away
from the center beam of the arm assembly. Do not place
cables closer than 5cm (2 in.) on either side of the beam.
CauTION
[a]
[26]
AV Cables
to TV
AV Cables from
Component
TV Power Outlet
(outside bellows)
Power
to TV
IR Reciever Eye
IR Reciever
Plug
Cable Loops
Bellows
No Cable
2” (5 cm)
No Cable
2” (5cm)
Cable Bar
Bottom Cross Bar
Cable Hole
Cable Tie Anchor
[07]
[06]
[B]
[C]