Satellite receiver/cable box installation – Sharp VC-MH835HM User Manual
Page 39
37
www.sharp.co.uk/support
CUSTOMISED INSTALLATION
SATELLITE RECEIVER/CABLE BOX INSTALLATION
If you wish to connect a satellite receiver to your VCR after auto-installation, it is not necessary
to completely re-install all channels. Follow the procedure below:
The installation procedure for cable boxes is the same as for satellite receivers. Sharp
cannot guarantee this feature will operate with all makes of satellite receiver or cable
box. (See the end of this manual for manufacturers codes.)
Follow the procedure below:
1
Press the
MENU
button.
2
Press [
/
]to select SET UP. Press
SET
to confirm.
3
CHANNEL PRESET
will be
highlighted. Press
SET
to confirm.
4
Press [
/
]to select
SAT
RECEIVER
. Press
SET
to confirm.
The satellite receiver screen will appear.
5
Follow points
9-13
in
AUTO
INSTALLATION OF A SATELLITE
RECEIVER/CABLE BOX
at the front
of this book.
6
Then press [
/
] to select
SAT
PROG SEARCH
. Press
SET
to
confirm. The satellite channels will be
installed. (This may take a few minutes).
7
Press
MENU
to leave this function.
NOTE:
A list of the preset digital channels can be found at the back of the operation manual.
MANUAL TUN I NG
SAT RECE I VER
SAT PROGRAM SEARCH
MANUAL TUN I NG
SAT RECE I VER
SAT PROGRAM SEARCH
6.
4.
MENU SELECT
BUTTONS
MENU
SET
SET
SET
SET
SET
TINS-A082UMN1.book Page 37 Monday, November 4, 2002 2:33 PM