Silvercrest SHGR 75 A1 - Manual (Page 4)

- 2 -
• The appliance becomes hot during use. Hold it
only by the grip when it is hot.
Intended use
The Hair Straightener is intended for the smoothing
and shaping of human hair only, under no circum-
stances may it to be used for wigs and hairpieces
made of synthetic material. The Hair Straightener is
intended for domestic use only. Pay heed to all of the
information in this operating manual, especially the
safety instructions.
Items supplied
• Hair Straighteners
• Operating Instructions
Technical data
Mains voltage: 220–240 V ~ 50 Hz
Power consumption, max.: 75 W
Protection class:
II /
Appliance description
1 Locking device
2 Hotplates
3 Control lamp
4 Heat level dial
5 On/Off switch
6 Suspension loop
Before straightening
• The hair should be clean, dry and free of sty-
ling products. Excepted are the special pro-
ducts that support a straightening of the hair.
• Comb the hair thoroughly before straightening
so that there are no knots in it.
• To achieve an especially good straightening
result, spread special products for hair straigh-
tening through the hair.
• Divide the hair into manageable portions and
secure the upper portions to the head with
grips so that they do not get in the way.
Operation
Preparation
Note:
The hotplates 2 must be free from contamina-
tion of all kinds. If necessary, clean them before
taking the appliance into use (see chapter
"Cleaning").
The appliance is locked, the locking device 1 has
been pushed into the position .
1. Insert the power plug into a wall socket.
2. Slide the On/Off switch 5 to the position I.
The control lamp 3 glows. The hotplates 2
are being warmed up.
3. Set the required temperature with the heat level
dial
4 :
• 1 - 2, minimum heat level, for very fine hair.
• 2 - 3, low heat level, for fine hair.
• 3 - 4, medium heat level, for normal hair.
• 4 - 5, highest heat level, for thick or difficult to
shape hair.
IB_SHGR75A1_49398_LB6 30.04.2010 9:11 Uhr Seite 2