Samsung 760 Series - Manual (Page 111)

English - 111
Network Connection - Cable
LAN Connection for a DHCP Environment
The procedures to set up the network using Dynamic Host Configuration Protocol (DHCP) are described below.
Since an IP address, subnet mask, gateway, and DNS are automatically allocated when DHCP is selected, you do
not have to enter them manually.
TV Rear Panel
The Modem Port on
the Wall
Modem Cable 
External Modem
(ADSL/VDSL/Cable TV)
LAN Cable 1
1 Connect the [LAN] port on the rear panel of the TV and the external modem with a LAN Cable.
 Connect the LAN port on the wall and the external modem with a Modem Cable.
TV Rear Panel
The Modem Port on
the Wall
External Modem
(ADSL/VDSL/Cable
TV)
IP Sharer
LAN Cable
Modem Cable
TV Rear Panel
LAN Cable
You can connect the LAN port and the TV directly depending on your network status.
The LAN Port on
the Wall
You can connect the LAN via a Sharer (Router).
LAN Cable
The terminals (the position of the port and the type) of the external device may differ depending on the
manufacturer.
If the IP address allocation by the DHCP server has failed, turn the external modem off, turn it on again after at
least 10 seconds and then try again.
For the connections between the external modem and the Sharer (Router), refer to the owner’s manual of the
corresponding product.
You can connect the TV to the LAN directly without connecting it through a Sharer (Router)
You cannot use a manual-connection-type ADSL modem because it does not support DHCP. You have to use
an automatic-connection-type ADSL modem.
➣
➣
➣
➣
➣
To access Samsung’s Infolink network feature, you must make one of the connections on the following pages.
Network Settings and InfoLink
BN68-01653A-Eng.indb 111 2008-08-27 오후 5:12:51