Smeg TLS8 - Manual (Page 16)

GB 16
INSTALLATION
Removal of transport bracket
The washing machine is fitted with a transport bracket to
avoid any possible damage during transport.
IMPORTANT: Before using the washing machine, the
transport bracket at the back MUST be removed.
1. Unscrew the two screws “A” and the four screws “B”
with a flat screwdriver or a No. 8 hex nut box spanner.
2. Remove the transport bracket.
3. Replace the four outer screws “B” on the machine and
tighten them.
4. Clip the two seals “C” supplied into the openings “D” of
the washing machine.
Note: do not forget to replace and tighten the four
outer screws.
2
1
1
4
C
A B
D
1
4
D
IFU-TL HR GB.fm Page 16 Thursday, June 7, 2007 2:23 PM