Sealife DIGITAL FLASH - Manual (Page 49)

47
i. For SeaLife digital cameras, set to External Flash mode.
Make sure camera’s ready-light is on.
ii. For other camera brands, set camera to Flash ON. Make
sure Red-Eye reduction is turned off. Refer to your camera
instructions for problems related to the camera.
d. Make sure the Digital Flash’s pre-flash cancellation switch is
properly set. Refer to page 12 for details.
e. If using Flash Link optical cable, make sure cable is properly
connected. Refer to trouble shooting guide in Flash Link
manual. Remove Flash Link sensor adapter and see if Digital
Flash fires when Flash Link is not connected. Test in a dark room.
3. Flash does not fire all the time.
a. Make sure Flash Link is correctly installed. The ends of the optical
cable must be in the correct position.
• The open end of the optical cable must be directly in front of
the camera’s flash.
• The flash sensor adapter must be centered over the Digital
Flash’s light sensor.