Sony SLV-EZ11AZ - Manual (Page 7)

7 Getting Started
Getting Started
You can use the WIDE button after entering a code number with any of the
following marks;
* 1 : Press WIDE to switch the wide picture mode on or off.
* 2 : Press WIDE, then press VOL +/– to select the wide picture mode you
want.
* 3 : Press WIDE. The menu appears on the TV screen. Then, press M/m/</
, to select the wide picture you want and press OK.
Notes
• If the TV uses a different remote control system from the one programmed to work
with the VCR, you cannot control your TV with the remote commander.
• You may not be able to use some buttons to control non-Sony TVs due to the remote
commander’s signal limitations.
• If you enter a new code number, the code number previously entered will be erased.
• When you replace the batteries of the remote commander, the code number may
automatically reset to 01 (Sony). If your TV is not a Sony, it is recommended to
manually set the appropriate code number every time you replace the batteries.
• If you set your TV’s code number correctly while the TV is turned on, the TV turns
off automatically.