Stanley Black & Decker 2005 Series - Manual (Page 2)

© Copyright 2006, Sargent & Greenleaf Page 2
t
o
o
pen the
L
ock
Make sure the keypad is turned counterclockwise to stop. Press
the code digits or letters in order, followed by
#. Then, within six
seconds, turn the keypad clockwise about 70 degrees, until it
comes to a positive stop.
Do not put any pressure on the safe
handle until after the keypad has been turned. To re-lock the
S&G
© D-Drive
™
, turn the keypad back counterclockwise to stop.
Note: The Master Code Holder is responsible for maintaining
the number of active users programmed into each lock.
I
n
c
ase of
t
roubLe
If your lock should fail to open when a valid code is entered,
check for the following:
1. The boltwork of a safe can, under certain conditions, place
pressure on the side of the lock’s bolt. This is often caused
by something inside the safe pressing against the door or
by something caught between the safe door and its frame.
When this occurs, the lock will not operate properly. To relieve
side pressure on the lock bolt, move the safe’s handle to
the fully locked position, make sure the keypad is turned
counterclockwise to stop, then re-enter a working code. The
lock should open.
2. If the lock “chirps” when keys are pressed, but it will not
open, the batteries may be drained to the point that they
will not operate the lock’s solenoid. Follow the battery
replacement procedure in this manual.
3. If the lock makes no sound when any of the keys are pressed,
dead batteries are likely to be the cause. Follow the battery
replacement procedure in this manual.
4. Your lock may be in penalty mode. If the lock interprets your
button presses as four or more incorrect codes in a row, it
will lock you out for ten minutes. During this period, the lock
will ignore any keypad inputs. At the end of ten minutes,
enter a valid code to open the lock.
If all of the preceding remedies have been exhausted
and the lock still does not open, contact a qualified safe
technician in your area for professional service.
O
perating
i
nstructiOns
S&G ® Z 03 D-Drive ™ Multi-User Electronic Safe Lock
2005 Series