Stanley Black & Decker 2005 Series - Manual (Page 9)

Page 9 © Copyright 2006, Sargent & Greenleaf
L
oW
b
attery
c
ondItIon
The S&G © X 03 D-Drive
™
lock uses one 9-volt alkaline battery,
which is housed in the keypad. We recommend Duracell ® brand.
If the battery needs to be replaced, the lock will emit five
double-beeps whenever it is opened. If this signal is ignored
and the battery becomes so weak that it will no longer operate
the lock, you’ll hear twenty quick beeps when you enter a code,
but the lock will not open. You will have to replace the battery
before your lock can be opened.
b
attery
r
epLacement
p
rocedure
Always perform a battery change with the container door open.
The lock will NOT forget your code(s) during battery change.
The circuitry is designed to hold this information for extended
periods of time even if there are no batteries installed. Codes
are stored in non-volatile memory.
Step 1—Pull the yellow, spring-loaded tab at the top of the
keypad (Figure 1) toward you slightly. It is not meant to separate
from the keypad. Once it’s pulled forward, carefully turn the
keypad ring counterclockwise to stop. Then pull the ring away
from its base far enough to expose the battery compartment.
Step 2—Put your finger in the battery compartment, and
carefully pull out the battery cables (Figure 2). There should be
enough slack to allow you to pull the connector and old battery
outside the compartment. Disconnect the old battery.
Step 3—S&G strongly recommends Duracell ® brand alkaline
batteries. No matter what brand is used, the battery must be
alkaline. Align the battery and connector terminals, and snap
the battery to the connector (Figure 3).
Figure 1
Figure 2
Figure 3
B
attery
c
hanging
i
nstructiOns
S&G ® Z 03 D-Drive ™ Multi-User Electronic Safe Lock
2005 Series