Sunpentown Intl Double Door Refrigerator RF-322W - Manual (Page 3)

3
ELECTRICAL REQUIREMENT
WARNING: DO NOT REMOVE GROUND PRONG.
DO NOT USE AN ADAPTOR.
DO NOT USE EXTENSION CORD.
Failure to follow these instructions can result in death, fire or
electrical shock.
Before you move your refrigerator into its final location, it is important to make sure you
have the proper electrical connection.
Recommended Grounding Method
This unit is applied with power supply of single-phase alternating current of 115V~,
60Hz. This appliance is equipped with a 3-prong (grounding) plug which mates with a
standard 3-prong wall outlet. DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR
REMOVE THE THIRD (GROUND) PRONG FROM THE POWER CORD. Unit should
be plugged in a dedicated outlet.
Use a receptacle which cannot be turned off with a switch or pull chain. Do not use an
extension cord.
NOTE: Before performing any type of installation, cleaning, or replacing a light bulb, turn
the refrigerator control to OFF and disconnect the refrigerator from electrical source.
When finished, reconnect the refrigerator to the electrical source and reset the control to
the desired setting.
LEVELING
If the refrigerator is not leveled during installation, the doors may not close or seal
properly, causing cooling, frost, or moisture problems. It is very important that the
refrigerator is leveled in order to function properly.
To level your refrigerator, turn the level leg clockwise to raise or turn counter-clockwise
to lower.
NOTE: Having someone push and tilt the unit backwards to take some weight off the
leveling leg will make adjustment easier.